LED Camera Test Beta

Test patterns drawn pixel for pixel at your wall's raster. Use them to find refresh banding, scan lines and moiré on camera, then dial each camera's shutter until the wall is clean.

The patterns are exact. The shutter numbers are starting points: processors, scan rates and camera sensors all vary, so confirm on camera. It's in active development. Send feedback

Wave & Signal Co.

Wall

Wall size
–
Cabinets
–
Aspect
–

Timing

Effective refresh
–
Refresh cycles per frame
–

Check what your processor does under genlock. Many lock refresh to the frame rate; some don't.

Output offset

Moves the raster on the output if the wall is mapped somewhere other than the top-left of the processor input.

Shutter math

Banding goes away when the exposure holds a whole number of the wall's refresh cycles. Rows marked Bands list the nearest clean setting. On broadcast cameras dial it in with Clear Scan or ECS in Hz; on cameras with fixed steps, pick a shutter that already reads Clean.

ShutterAngleExposureRefresh cyclesResultNearest cleanAngle

This covers the refresh (PWM) part of the problem. Scan multiplexing, the processor's own camera modes and each sensor's readout speed also play in, so treat these numbers as starting points and confirm on camera.

Checking a camera

  1. Open the fullscreen output on the display feeding the LED processor, or play the exported MP4 from your media server. On the slate, the white border should sit on the wall's outer edge, the cabinet grid should land on the seams and the circle should look round.
  2. Put up Low gray at 10%. Set each camera to the shutter the DP wants and look for horizontal bands, still or rolling.
  3. If it bands, find that shutter in the table above and dial the nearest clean value. Confirm on 5% and on Gray steps, where you can see every level at once.
  4. Switch to Moiré and rack focus soft. Patterns that disappear are moiré (change distance, focal length or focus). Bands that stay are refresh.
  5. Run Sync from a genlocked source, ideally the exported MP4 on the media server. A camera in phase with the wall shows one solid box on the ladder per frame. Two dimmer neighbors mean the exposure straddles two wall frames, so check genlock and phase.
  6. Write down the clean shutter for each camera.
← → pattern ↑ ↓ gray level L labels Space pause motion Esc exit fullscreen