Sync Test

Drop in a recording of the blip slate and get the audio delay for the stream. The page finds the flash and the tone on its own and measures every blip in the clip. Nothing is uploaded; the analysis runs in your browser.

Wave & Signal Co.

Recording

Settings

ms
If the recording was made with delay already dialed in, enter it here and the page gives you the new total.
Match the console or DSP you're dialing the delay into.
ms
Leave at 0 to match what you'd read in Premiere. Optional: the BlipTest 29.97 file itself starts its tone 22.7 ms before the bars, so enter −22.7 (or load the original slate file with Calibrate) to take that out of every measurement.
ms
The iPad’s own timing between its screen and speaker. Measure it once per iPad: record the slate on your phone, close up, for 30 seconds, then load that clip with Calibrate above. Used only for Sync Slate recordings.
Hz
Leave on auto unless the room is loud and the page locks onto the wrong sound.

Shooting the test

  1. Record the final output — the stream recording or program record, not a camera ISO.
  2. Hold the iPad steady and big enough to cover a few percent of the frame. Brightness all the way up.
  3. Let at least four blips run (about 20 seconds). More blips make a steadier number.
  4. Keep the tone clean and well above the room. Talking over it is fine; music is harder.
  5. For the most accurate number, run the Sync Slate on the iPad instead of the blip video and record at least 30 seconds. The page recognizes it on its own.
Example result
Delay audio
—

Blip 1

Picture (flash level per frame)Sound (tone)
Grey ticks are frame boundaries. Times are relative to the flash.

Flash area

Found automatically. Drag a box to pick it yourself.

Every blip

#Flash frameToneOffsetFramesSamples
Flash and tone times read like Premiere with audio time units on (hh:mm:ss:samples), counted from the start of the clip. Negative offset = sound arrives before picture. Offsets and samples include the slate reference correction; the Premiere range does not, so it matches what your op marks.
Accuracy: with a standard blip video, any measurement, here or in an editor, is good to about half a frame (±17 ms at 29.97), because the picture can only change once per frame. The Sync Slate, which sweeps a bar at the iPad’s full refresh rate, gets within a couple of milliseconds. How it reads: the flash starts at the first clearly lit frame and the tone at the start of its rise. The sub-frame estimate also counts a partly lit frame just before the flash.